Dock Repair and TIG Welding on Lake Minnie Belle Near Litchfield

We rolled out to Lake Minnie Belle south of Litchfield to handle a dock repair that needed some real attention. The dock frame had structural issues that weren't going to fix themselves - and with lake season picking up, the customer needed it sorted out fast. We loaded up the truck, grabbed the Miller TIG welder, and got after it.

Welding on a dock isn't like welding in a shop. You're working low to the ground, dealing with wind off the water, awkward angles, and conditions that test your equipment and your patience. That's just part of the job. We hung welding blankets around the work area to shield the arc from the wind and dialed in the machine to get clean, consistent passes on every joint.

TIG welding is the right call for this kind of structural dock repair. It gives you tight control over the heat input, which matters a lot when you're working on a frame that's going back into service on the water. The finished welds are strong, clean, and built to hold up through freeze-thaw cycles and everything the lake throws at it season after season.

The whole point is getting the customer back on their dock without it being a headache. No halfway fixes. We work through the problem, do the repair right, and leave the setup ready to use. If your dock or any aluminum lake structure is showing cracks, broken welds, or weak joints - that's something we can take care of.